Top bar178 link alternatif Secrets
Top bar178 link alternatif Secrets
Blog Article
All spun cylinders and plugged cylinders has to be examined for leakage by dry gasoline or dry air force just after the bottom has actually been cleaned and is totally free from all moisture, issue to the next situations and constraints:
Mechanical exams has to be carried out to ascertain produce toughness, tensile toughness, elongation being a share, and reduction of location of fabric for a percentage, as follows:
Pressure-retaining products have to be recognized by any ideal method that does not compromise the integrity of your cylinder. Plates and billets for hotdrawn cylinders have to be marked with the heat selection.
(ii) A person cylinder needs to be selected from each lot and become hydrostatically tension analyzed to destruction. If this cylinder bursts underneath five (five) periods the support strain, then two more cylinders within the similar ton as being the Formerly examined cylinder must be picked and subjected to this check.
(1) Specimens has to be taken from a single cylinder just after heat treatment as illustrated in appendix A to this subpart, picked at random from Each and every wide range of two hundred or much less, as follows:
Reheat treatment of turned down cylinders is approved a single time. Subsequent thereto, cylinders will have to pass all prescribed tests for being satisfactory.
(iv) Everlasting volumetric growth might not exceed ten per cent of the overall volumetric growth at take a look at strain.
(one) For spheres the check need to be within the weld concerning parallel steel plates on the press with welded seam at correct angles to your plates.
The metal Utilized in the construction on the cylinder need to be as laid out in desk 1 of appendix A to this aspect. The cylinder manufacturer have to sustain a document of deliberately extra alloying elements.
(one) Circumferential seams has to be by brazing only. Heads has to be attached to shells because of the lap brazing method and have to overlap not less than four times the wall thickness. Brazing content need to have a melting issue of not under one thousand °File.
(one) Force, click here somewhere around similar to but no a lot less than provider force, needs to be placed on one particular side on the finished base around a place of at the very least 1⁄16 of the overall region of the bottom but not lower than 3⁄4 inch in diameter, including the closure, for a minimum of 1 moment, for the duration of which period another side of The underside subjected to stress has to be lined with drinking water and carefully examined for indications of leakage. Besides as offered in paragraph (n) of the area, a cylinder that is definitely leaking must be turned down.
There needs to be no proof of cracking on the sample when it can be flattened concerning flat plates to no more than 6 (6) occasions the wall thickness. If this check fails, one additional sample from the same ton can be taken. If this second sample fails, the entire whole lot has to be turned down.
(ii) Taper threads needs to be of a size not fewer than as specified for American Regular taper pipe threads.
Tests is necessary on two (2) specimens faraway from a single cylinder or section thereof taken at random out of every great deal of 200 or less. Samples has to be eliminated right after warmth remedy as illustrated in appendix A to this subpart.